Removing and installing front seat trim, front seat with height adjustment mechanism — VW

🧭 Before you start

Fits: platform codes 121, BL1

• Renewed: if necessary

Don't miss

• The Easy Entry lever is not shown in the figure.The Easy Entry lever replaces cover (2).
• Before installing, check all fasteners for damage and renew if necessary.

📋 Procedure

1. Move front seat to foremost position using longitudinal adjustment mechanism.
2. Release cover (2) from front seat trim (1) using removal wedge3409.
3. Remove Easy Entry lever . [Note: The Easy Entry lever is not shown in the figure.The Easy Entry lever replaces cover (2).]
4. Remove seat height adjustment operating lever .
5. Remove spreader pin (3) and remove spreader clip (4) from front seat trim (1).

6. Pull front seat trim (1) over shaft (6).
7. Push front seat trim (1) in direction of travel out of mounting in seat frame (arrow). [Note: Before installing, check all fasteners for damage and renew if necessary.]
8. Install in reverse order of removal.
9. Remove backrest adjustment lever (6).
10. Remove spreader pin (5) and remove spreader clip (4) from front seat trim (1).
11. Pull front seat trim (1) over shaft (2).
12. Push front seat trim (1) in direction of travel out of mounting (3) in seat frame. [Note: Before installing, check all fasteners for damage and renew if necessary.]
13. Install in reverse order of removal.

Other VW procedures

• Removing engine · 41 torque figures
• Removing and installing camshaft – VW Golf Cabriolet · 47 torque figures
• Adjusting valve timing – VW Passat B5 · 83 torque figures
• Removing and installing camshafts – VW Passat B6 · 39 torque figures
• Removing and installing coolant pump · 53 torque figures
• Installing mechatronics – VW Golf IV / Bora · 2 torque figures
• Technical data, gearbox
• Assembling bevel box – VW Golf IV / Bora
• Installing wiper motor in wiper frame – VW · 1 torque figures
• Front axle speed sensor - remove and install · 2 torque figures