Removing and installing rear door puller — VW
Removing and installing rear door puller on VW: 3 steps, 1 torque figure. What to remove, what to tighten and to how many Nm, what to check after.
Workshop procedure for VW — the exact step sequence and torque figures, straight from real workshop data.
🧭 Before you start
- Special tools named: puller
- Renewed: if necessary
Don't miss
- Before installing, check all fasteners for damage and renew if necessary.
🔩 Torque settings
Values can differ between engine variants — check the code stamped on your block.
| Torque | Fastener / step |
|---|---|
| 1.5 Nm (1.1 lb-ft) | Unscrew bolts (1 |
ℹ️ Always cross-check the exact figure against your vehicle's factory manual before final tightening — a wrong torque can damage the engine. These values are extracted from workshop data and may not cover every variant or revision.
📋 Procedure
- Remove rear door trim (see the separate procedure).
- Unscrew bolts (1) (1.5 Nm). — 1.5 Nm (1.1 lb-ft)
- Swing door puller (2) in (direction of arrow) and remove it from rear door trim. [Note: Before installing, check all fasteners for damage and renew if necessary.]
Other VW procedures
- Removing engine · 41 torque figures
- Removing and installing camshaft – VW Golf Cabriolet · 47 torque figures
- Adjusting valve timing – VW Passat B5 · 83 torque figures
- Removing and installing camshafts – VW Passat B6 · 39 torque figures
- Removing and installing coolant pump · 53 torque figures
- Installing side window on window regulator – VW Golf Cabriolet · 1 torque figures
- Removing and installing brake pads, rear brakes, Bosch – VW
- Removing and installing brake caliper, rear brake C 38 – VW
- Removing and installing reducing agent delivery line – VW CFFA
- Removing and installing over-centre spring, CC
Who makes these pages, and how
TorqFix was built by a mechanic — after a 2,700 km drive with five roadside repairs that no diagnostic tool could explain.
The figures on this page come from manufacturer workshop documentation and are shown as they are. The page is assembled automatically from that data — it is not written by an AI. The AI works in the chat, where it answers for your specific car. It writes nothing here.
Variants of the same model differ. Cross-check torque against the factory manual for your engine before final tightening.
Seen a figure that does not match your manual? Write to us — we correct it and note when. support@torqfix.com
The story behind TorqFix → · How these pages are made →Workshop data on this page last updated 20 Sep 2026.