Installing side window on window regulator: VW Golf Cabriolet
Step-by-step installing side window on window regulator for the VW Golf Cabriolet: 5 steps, 1 torque figure.
Workshop procedure for VW — the exact step sequence and torque figures, straight from real workshop data.
🧭 Before you start
Fits: VW Golf Cabriolet (517, 2011–2016)
🔩 Torque settings
Values can differ between engine variants — check the code stamped on your block.
| Torque | Fastener / step |
|---|---|
| 6 Nm (4.4 lb-ft) | Tighten hexagon nuts (6 |
ℹ️ Always cross-check the exact figure against your vehicle's factory manual before final tightening — a wrong torque can damage the engine. These values are extracted from workshop data and may not cover every variant or revision.
📋 Procedure
- Place plastic washers (4 and 5) flush on side window.
- Guide retaining bracket (2) through side window (1) with threaded pins (3).
- Place side window (1) on window regulator (7).
- Tighten hexagon nuts (6). Torque setting: 6 Nm. — 6 Nm (4.4 lb-ft)
- Install side window with window regulator.
Other VW procedures
- Removing engine · 41 torque figures
- Removing and installing camshaft – VW Golf Cabriolet · 47 torque figures
- Adjusting valve timing – VW Passat B5 · 83 torque figures
- Removing and installing camshafts – VW Passat B6 · 39 torque figures
- Removing and installing coolant pump · 53 torque figures
- Renewing left drive flange oil seal – VW
- Removing and installing bearing housing – VW
- Renewing spur gear for crankshaft – VW 2.0 TDI
- Removing and installing Lambda probe 2G108 and Lambda probe 2 after catalytic converter G131
- Removing and installing engine control units – VW Phaeton
Who makes these pages, and how
TorqFix was built by a mechanic — after a 2,700 km drive with five roadside repairs that no diagnostic tool could explain.
The figures on this page come from manufacturer workshop documentation and are shown as they are. The page is assembled automatically from that data — it is not written by an AI. The AI works in the chat, where it answers for your specific car. It writes nothing here.
Variants of the same model differ. Cross-check torque against the factory manual for your engine before final tightening.
Seen a figure that does not match your manual? Write to us — we correct it and note when. support@torqfix.com
The story behind TorqFix →Workshop data on this page last updated 20 Sep 2026.