TorqFix

Removing and installing left and right latch switches for convertible roof F169 / F170 — VW

Removing and installing left and right latch switches for convertible roof F169 / F170 on VW: 10 steps.

Workshop procedure for VW — the exact step sequence and torque figures, straight from real workshop data.

10 steps

🧭 Before you start

Fits: VW Golf Cabriolet (517, 2011–2016)

📋 Procedure

  1. Remove windscreen frame trim General body repairs, interior70Trim, insulation; Roof trim
  2. Release line from connector (5).
  3. Detach retainer (4).
  4. Remove bolts (2).
  5. Remove end plate (1) with latch switch for convertible roof (3).
VW? Steps differ between engine variants — check this job against your exact car before you commit to it. Check my car — free →
  1. Insert end plate (1) with latch switch for convertible roof (3).
  2. Tighten bolts (2).
  3. Secure line to connector (5).
  4. Secure retainer (4).
  5. Install trim for windscreen frame General body repairs, interior70Trims, insulation; Roof trim.

Other VW procedures

Who makes these pages, and how

TorqFix was built by a mechanic — after a 2,700 km drive with five roadside repairs that no diagnostic tool could explain.

The figures on this page come from manufacturer workshop documentation and are shown as they are. The page is assembled automatically from that data — it is not written by an AI. The AI works in the chat, where it answers for your specific car. It writes nothing here.

Variants of the same model differ. Cross-check torque against the factory manual for your engine before final tightening.

Seen a figure that does not match your manual? Write to us — we correct it and note when. support@torqfix.com

The story behind TorqFix →

Workshop data on this page last updated 20 Sep 2026.