Adjusting sliding/tilting roof solar panel height: VW Passat B5
Step-by-step adjusting sliding/tilting roof solar panel height for the VW Passat B5: 5 steps, 1 torque figure.
Workshop procedure for VW — the exact step sequence and torque figures, straight from real workshop data.
🧭 Before you start
Fits: VW Passat B5 (3B)
🔩 Torque settings
Values can differ between engine variants — check the code stamped on your block.
| Torque | Fastener / step |
|---|---|
| 4.5 Nm (3.3 lb-ft) | Tighten screws for solar panel |
ℹ️ Always cross-check the exact figure against your vehicle's factory manual before final tightening — a wrong torque can damage the engine. These values are extracted from workshop data and may not cover every variant or revision.
📋 Procedure
- Open sliding/tilting sunroof about 10 cm towards rear.
- Pull trim (2) downwards in the middle (arrow) out of mounting (1).
- Push trim towards rear.
- Close glass panel.
- Tighten screws for solar panel 4.5 Nm. — 4.5 Nm (3.3 lb-ft)
Other VW procedures
- Removing engine · 41 torque figures
- Removing and installing camshaft – VW Golf Cabriolet · 47 torque figures
- Adjusting valve timing – VW Passat B5 · 83 torque figures
- Removing and installing camshafts – VW Passat B6 · 39 torque figures
- Removing and installing coolant pump · 53 torque figures
- Removing and installing rear light in rear lid, vehicles 11.03 ▸ · 1 torque figures
- Adjusting output shaft for 5th, 6th and reverse gears – VW 2.0
- Leak-proofness of the steering system - check
- Differential - disassemble and assemble
- 4 - Speed automatic gearbox 001 — 1st to 3rd gear clutch -K1-: disassemble and assemble
Who makes these pages, and how
TorqFix was built by a mechanic — after a 2,700 km drive with five roadside repairs that no diagnostic tool could explain.
The figures on this page come from manufacturer workshop documentation and are shown as they are. The page is assembled automatically from that data — it is not written by an AI. The AI works in the chat, where it answers for your specific car. It writes nothing here.
Variants of the same model differ. Cross-check torque against the factory manual for your engine before final tightening.
Seen a figure that does not match your manual? Write to us — we correct it and note when. support@torqfix.com
The story behind TorqFix →Workshop data on this page last updated 20 Sep 2026.