Removing and installing front window regulator drive — VW
Removing and installing front window regulator drive on VW: 7 steps, 1 torque figure. What to remove, what to tighten and to how many Nm, what to check.
Workshop procedure for VW — the exact step sequence and torque figures, straight from real workshop data.
🧭 Before you start
Fits: platform codes 121, BL1
🔩 Torque settings
Values can differ between engine variants — check the code stamped on your block.
| Torque | Fastener / step |
|---|---|
| 3 Nm (2.2 lb-ft) | Tighten bolts (2 |
ℹ️ Always cross-check the exact figure against your vehicle's factory manual before final tightening — a wrong torque can damage the engine. These values are extracted from workshop data and may not cover every variant or revision.
📋 Procedure
- If fitted, remove window winder .
- Remove front door trim General body repairs, interior70Door trims; Removing and installing front door trim.
- Secure door window against sliding down with adhesive tape.
- Remove bolts (2) (Qty. 3).
- Remove window lifter mechanism (1) from mounting brackets of cable drum (3).
- Fit window lifter mechanism (1) onto mounting brackets of cable drum (3). Move door window up and down slightly so that the splines between window lifter mechanism and cable drum engage more easily.
- Tighten bolts (2) (qty. 3) to specified tightening torque of 3 Nm. — 3 Nm (2.2 lb-ft)
Other VW procedures
- Removing engine · 41 torque figures
- Removing and installing camshaft – VW Golf Cabriolet · 47 torque figures
- Adjusting valve timing – VW Passat B5 · 83 torque figures
- Removing and installing camshafts – VW Passat B6 · 39 torque figures
- Removing and installing coolant pump · 53 torque figures
- Aligning exhaust system free of tension, Polo · 1 torque figures
- Removing and installing expansion valve, Golf 2009, Golf Cabriolet 2012 · 1 torque figures
- Removing and installing coolant circulation pump before power electronics V508 · 1 torque figures
- Removing and installing coolant circulation pump before high voltage PTC heater V509 · 1 torque figures
- Removing and installing luggage compartment cover side cover · 1 torque figures
Who makes these pages, and how
TorqFix was built by a mechanic — after a 2,700 km drive with five roadside repairs that no diagnostic tool could explain.
The figures on this page come from manufacturer workshop documentation and are shown as they are. The page is assembled automatically from that data — it is not written by an AI. The AI works in the chat, where it answers for your specific car. It writes nothing here.
Variants of the same model differ. Cross-check torque against the factory manual for your engine before final tightening.
Seen a figure that does not match your manual? Write to us — we correct it and note when. support@torqfix.com
The story behind TorqFix →Workshop data on this page last updated 20 Sep 2026.