Installing side window with window regulator — VW
Installing side window with window regulator on VW: 7 steps, 2 torque figures. What to remove, what to tighten and to how many Nm, what to check after.
Workshop procedure for VW — the exact step sequence and torque figures, straight from real workshop data.
🧭 Before you start
Fits: platform code 1F7
🔩 Torque settings
Values can differ between engine variants — check the code stamped on your block.
| Torque | Fastener / step |
|---|---|
| 10 Nm (7.4 lb-ft) | Screw lock nuts (4) onto studs (3) on window regulator, specified torque |
| 10 Nm (7.4 lb-ft) | Screw securing nuts (7) onto studs (6 |
ℹ️ Always cross-check the exact figure against your vehicle's factory manual before final tightening — a wrong torque can damage the engine. These values are extracted from workshop data and may not cover every variant or revision.
📋 Procedure
- Insert side window (1) with window regulator (2) into window slot (arrow) from above.
- Reconnect connection (5) for window regulator motor.
- Place window regulator onto studs (6).
- Screw securing nuts (7) onto studs (6). Specified torque: 10 Nm — 10 Nm (7.4 lb-ft)
- Screw lock nuts (4) onto studs (3) on window regulator, specified torque: 10 Nm. — 10 Nm (7.4 lb-ft)
- Check adjustment of side window and readjust side window as necessary .
- Check function.
Other VW procedures
- Removing engine · 41 torque figures
- Removing and installing camshaft – VW Golf Cabriolet · 47 torque figures
- Adjusting valve timing – VW Passat B5 · 83 torque figures
- Removing and installing camshafts – VW Passat B6 · 39 torque figures
- Removing and installing coolant pump · 53 torque figures
- Removing and installing bevel box (vehicles with 4-cylinder engine)
- Draining and filling coolant system – VW 1.6
- Checking Lambda probe ageing, Lambda probe before catalyst
- Checking Lambda probe ageing Lambda probe 1
- Renewing electrical parts
Who makes these pages, and how
TorqFix was built by a mechanic — after a 2,700 km drive with five roadside repairs that no diagnostic tool could explain.
The figures on this page come from manufacturer workshop documentation and are shown as they are. The page is assembled automatically from that data — it is not written by an AI. The AI works in the chat, where it answers for your specific car. It writes nothing here.
Variants of the same model differ. Cross-check torque against the factory manual for your engine before final tightening.
Seen a figure that does not match your manual? Write to us — we correct it and note when. support@torqfix.com
The story behind TorqFix →Workshop data on this page last updated 20 Sep 2026.