Adjusting window regulator — VW
Adjusting window regulator on VW: 3 steps, 2 torque figures. What to remove, what to tighten and to how many Nm, what to check after.
Workshop procedure for VW — the exact step sequence and torque figures, straight from real workshop data.
🧭 Before you start
Fits: platform codes 1H1, 1H2
🔩 Torque settings
Values can differ between engine variants — check the code stamped on your block.
| Torque | Fastener / step |
|---|---|
| 10 Nm (7.4 lb-ft) | Move the door window down |
| 10 Nm (7.4 lb-ft) | Move the door window up but not all the way (50 mm below the top window position - this… |
ℹ️ Always cross-check the exact figure against your vehicle's factory manual before final tightening — a wrong torque can damage the engine. These values are extracted from workshop data and may not cover every variant or revision.
📋 Procedure
- Undo mounting bolts (2) and (3) on the window regulator.
- Move the door window up but not all the way (50 mm below the top window position - this is more stable). Tighten top mounting bolts (2) for the window regulator (10 Nm). — 10 Nm (7.4 lb-ft)
- Move the door window down. Tighten bottom mounting bolts (3) for the window regulator; specified torque: 10 Nm. — 10 Nm (7.4 lb-ft)
Other VW procedures
- Removing engine · 41 torque figures
- Removing and installing camshaft – VW Golf Cabriolet · 47 torque figures
- Adjusting valve timing – VW Passat B5 · 83 torque figures
- Removing and installing camshafts – VW Passat B6 · 39 torque figures
- Removing and installing coolant pump · 53 torque figures
- Assembly overview - clutch hydraulics, Scirocco, RHD vehicles
- Removing and installing centre crash sensor for pedestrian protection G693
- Removing and installing high-voltage battery charging socket 1 UX4
- Removing and installing fuel pressure regulating valve N276, version 2
- Removing and installing exhaust gas temperature sender 2 G448, vehicles with SCR system
Who makes these pages, and how
TorqFix was built by a mechanic — after a 2,700 km drive with five roadside repairs that no diagnostic tool could explain.
The figures on this page come from manufacturer workshop documentation and are shown as they are. The page is assembled automatically from that data — it is not written by an AI. The AI works in the chat, where it answers for your specific car. It writes nothing here.
Variants of the same model differ. Cross-check torque against the factory manual for your engine before final tightening.
Seen a figure that does not match your manual? Write to us — we correct it and note when. support@torqfix.com
The story behind TorqFix →Workshop data on this page last updated 20 Sep 2026.