Removing and installing front right coolant pipe: VW Passat B8 (CDLJ, CKFC, CLHA, CLHB, …)

🧭 Before you start

Fits: VW Passat B8 (3G, 2014–)

• Opens: coolant

Don't miss

• Secure all hose connections with hose clips meeting production standard Electronic Parts Catalogue.

🔧 Engine codes this applies to

📋 Procedure

1. Remove engine cover panel .
2. Drain coolant .
3. Remove air duct .
4. Remove radiator cowl .
5. Install protective matVAS 531003 to vehicle as shown in illustration.

6. Remove poly V-belt .
7. Remove air conditioner compressor with refrigerant lines connected from bracket Heating, air conditioning87Air conditioner compressor; Removing and installing air conditioner compressor from and to bracket, and tie it up to right side.
8. Release hose clips (3), and pull off coolant hoses (2).
9. Remove bolt (arrow).
10. Remove front right coolant pipe (1).
11. Open clips (arrows), and pull off coolant hose (2). [Note: Secure all hose connections with hose clips meeting production standard Electronic Parts Catalogue.]
12. Replenish coolant .
13. Fit engine cover panel .

Other VW procedures

• Removing and installing vibration damper – VW Golf Cabriolet · 3 torque figures
• Checking radial clearance of conrods · 5 torque figures
• Removing and installing oil filter housing – VW Polo 6C · 3 torque figures
• Assembly overview - sump, oil pump · 5 torque figures
• Separating engine and gearbox · 1 torque figures
• Removing engine · 41 torque figures
• Removing and installing camshaft – VW Golf Cabriolet · 47 torque figures
• Adjusting valve timing – VW Passat B5 · 83 torque figures
• Removing and installing camshafts – VW Passat B6 · 39 torque figures
• Removing and installing coolant pump · 53 torque figures