Removing and installing coolant pipe between heat exchanger and auxiliary/supplementary heater — VW

🧭 Before you start

Fits: VW Sharan II / SEAT Alhambra (7N, 2010–)

📋 Procedure

1. Remove front noise insulation General body repairs, exterior66Noise insulation; Assembly overview - noise insulation.
2. Remove engine cover panel 10Engine cover panel; Removing and installing engine cover panel.
3. On some engine versions additional components may have to be removed, to ease access to the coolant pipe.
4. Clamp off coolant hoses using hose clamps to 25 mm3094.
5. If fitted, remove heat insulation grommet.

6. Unclip retaining clip (5).
7. Unscrew nuts (2) and (3).
8. Pull hose set (1) forwards.
9. Remove bolt (7).
10. Loosen clamp (6).
11. Release retaining clips (4).
12. Pull coolant hoses off coolant pipe.
13. Remove coolant pipe (8).
14. Install in reverse order.

Other VW procedures

• Removing engine · 41 torque figures
• Removing and installing camshaft – VW Golf Cabriolet · 47 torque figures
• Adjusting valve timing – VW Passat B5 · 83 torque figures
• Removing and installing camshafts – VW Passat B6 · 39 torque figures
• Removing and installing coolant pump · 53 torque figures
• Removing and installing fuel system diagnosis pump
• Checking current draw of fuel pump – VW Golf V / Jetta
• Removing and installing clutch engagement, gearboxes made up to 05.2011
• Removing and installing oil spray jets – VW Jetta VI
• Removing and installing lock carrier trim – VW Touran II