Removing and installing clutch position sender G476, LHD vehicles — VW

🧭 Before you start

Fits: VW Sharan II / SEAT Alhambra (7N, 2010–), VW Tiguan I (5N, 2007–2016)

📋 Procedure

1. If a coded radio is installed, obtain anti-theft code.
2. Remove complete air filter housing, if it is located near the battery.
3. Remove battery and battery tray Electrical system27Battery; Removing and installing battery and Electrical system27Battery; Removing and installing battery tray.
4. Remove cover (1) of cable guide.
5. Use a long screwdriver to detach cable guide (arrow 1) between brake servo (2) and fuse box (3).

6. Then, push »lug« below supply hose (1) on clutch position sender G476(2) in (direction of arrow).
7. ⚠ Please observe the following points during all installation work, in particular in the engine compartment, due to the space limitations:Risk of cuts on sharp-edged components.To avoid damaging lines or components, make sure there is sufficient clearance from all moving or hot components. — Disconnect connector (1) on clutch master cylinder (2).
8. Pull released clutch position sender G476(1) downwards in (direction of arrow) out of clutch master cylinder (2).
9. Push clutch position sender G476(1) upwards into clutch master cylinder (2) until it engages in locking mechanism.
10. Verify correct installation position from below, and push on clutch position sender G476 again as necessary.
11. Connect connector (1) to clutch master cylinder (2).
12. Install cover (1) for cable guide.
13. Install battery and battery tray Electrical system27Battery; Removing and installing battery and Electrical system27Battery; Removing and installing battery tray.
14. If removed beforehand, install air filter housing:

Other VW procedures

• Removing engine · 41 torque figures
• Removing and installing camshaft – VW Golf Cabriolet · 47 torque figures
• Adjusting valve timing – VW Passat B5 · 83 torque figures
• Removing and installing camshafts – VW Passat B6 · 39 torque figures
• Removing and installing coolant pump · 53 torque figures
• Removing and installing rear right coolant pipe (engine codes CASA and CASD)
• Removing and installing right intermediate pipe – VW 3.0 TDI
• Removing and installing, checking thermostat – VW 3.6
• Removing and installing Hall sender – VW 2.0 TDI
• Renewing cornering light bulb – VW Tiguan I