Removing and installing, checking thermostat: VW Touareg II 3.6 (BHK, BHL, CGRA, CMTA)

🧭 Before you start

Fits: VW Touareg II (7P, 2010–2018)

• Opens: coolant

Don't miss

• There should be a metal sleeve (arrow) in the coolant connection. If this is missing, the coolant connection must be replaced.

🔧 Engine codes this applies to

📋 Procedure

1. Remove noise insulation General body repairs, exterior50Noise insulation.
2. Drain coolant .
3. Remove coolant hoses (1) and (2) from intake manifold.
4. Unscrew bolts (arrows) and remove coolant connection with coolant hose.
5. Remove thermostat from coolant pipe. [Note: There should be a metal sleeve (arrow) in the coolant connection. If this is missing, the coolant connection must be replaced.]

6. Clean sealing surface for O-ring.
7. Insert thermostat into coolant pipe.
8. Moisten new seal with coolant and fit on coolant connection.
9. Fit coolant connection with seal and tighten bolts alternately and diagonally.
10. Secure coolant hoses to intake manifold.
11. Replenish coolant .
12. Install noise insulation General body repairs, exterior50Noise insulation.
13. Heat thermostat in water.

Other VW procedures

• Measuring radial clearance of camshafts – Audi Q7 · 2 torque figures
• Checking fuel pressure and residual pressure (up to high-pressure pump)
• Removing and installing fuel tank with attached components
• Removing and installing catalytic converters – VW 3.6
• Removing and installing Lambda probes – Audi Q7
• Removing engine · 41 torque figures
• Removing and installing camshaft – VW Golf Cabriolet · 47 torque figures
• Adjusting valve timing – VW Passat B5 · 83 torque figures
• Removing and installing camshafts – VW Passat B6 · 39 torque figures
• Removing and installing coolant pump · 53 torque figures