Removing and installing right intermediate pipe: VW Touareg II 3.0 TDI (CASA, CASD, CATA)
Step-by-step removing and installing right intermediate pipe for the VW Touareg II 3.0 TDI: 13 steps.
Workshop procedure for VW — the exact step sequence and torque figures, straight from real workshop data.
🧭 Before you start
Fits: VW Touareg II (7P, 2010–2018)
- Opens: coolant
- Renewed: seals
Don't miss
- Shown in illustration with engine removed.
📐 18 workshop diagrams for CASA
Real factory drawings for this job — timing marks, bolt locations and routing. Locked in the free view.
📋 Procedure
- Remove engine cover panel .
- Drain coolant .
- Unclip breather hose (1) for differential from upper part of air filter.
- Disconnect electrical connector (3) at air mass meter G70.
- Remove air hose (4) from turbocharger.
- Release retaining clips (2) and remove upper part of air filter housing.
- Remove electrical connector (arrow) from bracket and separate.
- Unbolt bracket for electrical connector from cylinder head cover.
- Detach coolant hose (arrow) from coolant expansion tank.
- Remove bolts (2) and (3).
- Pull air intake pipe forwards off air intake hose, loosen hose clip (1) for this.
- Remove bolt connections (1 … 4) and remove intermediate pipe. [Note: Shown in illustration with engine removed.] [Note: Renew seals and gaskets.]
- Fill with coolant .
Ask TorqFix about your VW CASA — it answers with the exact sequence for that engine and the workshop drawing for each step. First question is free after a 20-second sign-up, no card.
Ask about your VW CASA — free → or sign up free to see the drawingsOther VW procedures
- Removing and installing mounting plate for oil cooler, pressure control valve and oil filter housing · 1 torque figures
- Removing and installing mounting plate for engine oil cooler, pressure control valve and oil filter housing
- Removing and installing intake manifold (bottom section, left-side) - vehicles with engine codes BUG and BUN
- Removing and installing thermostat with union (engine codes CASA and CASD) · 1 torque figures
- Checking return flow rate of injectors (piezo injectors) with engine running.
- Removing engine · 41 torque figures
- Removing and installing camshaft – VW Golf Cabriolet · 47 torque figures
- Adjusting valve timing – VW Passat B5 · 83 torque figures
- Removing and installing camshafts – VW Passat B6 · 39 torque figures
- Removing and installing coolant pump · 53 torque figures
Who makes these pages, and how
TorqFix was built by a mechanic — after a 2,700 km drive with five roadside repairs that no diagnostic tool could explain.
The figures on this page come from manufacturer workshop documentation and are shown as they are. The page is assembled automatically from that data — it is not written by an AI. The AI works in the chat, where it answers for your specific car. It writes nothing here.
Variants of the same model differ. Cross-check torque against the factory manual for your engine before final tightening.
Seen a figure that does not match your manual? Write to us — we correct it and note when. support@torqfix.com
The story behind TorqFix →Workshop data on this page last updated 20 Sep 2026.