Removing and installing B-pillar trims — VW
Removing and installing B-pillar trims on VW: 9 steps, 1 torque figure. What to remove, what to tighten and to how many Nm, what to check after.
Workshop procedure for VW — the exact step sequence and torque figures, straight from real workshop data.
🧭 Before you start
Fits: platform codes 602, 612, 642, 604, 644, 614
- Renewed: if necessary
🔩 Torque settings
Values can differ between engine variants — check the code stamped on your block.
| Torque | Fastener / step |
|---|---|
| 40 Nm (30 lb-ft) | Remove bolt (1 |
ℹ️ Always cross-check the exact figure against your vehicle's factory manual before final tightening — a wrong torque can damage the engine. These values are extracted from workshop data and may not cover every variant or revision.
📋 Procedure
- Remove sill strip .
- Detach lower end of trim (1) from catch (3) in (direction of arrow B).
- Detach lower end of trim (1) from catch (4) in (direction of arrow B).
- Detach upper end of trim (1) from catch (2).
- Remove bolt (1) (40 Nm). — 40 Nm (30 lb-ft)
- Thread seat belt (2) through the hole in the trim.
- Release lower trim (2) at upper end from the catches (1) in direction of (arrow A).
- Release lower end of lower trim (2) from catch (3) in direction of (arrow B).
- After installing the trim, it must be ensured that the trim is in door seal beading. [Note: Before installing, check all fasteners for damage and renew if necessary.Models with seat belt height adjustment: before installing ensure belt height adjuster is located correctly on body and slide of adjuster is in highest position on trim.After installation is complete, a functional check of belt height adjuster must be performed.Ensure seat belt is positioned correctly and seat belt is free to move.]
Other VW procedures
- Removing engine · 41 torque figures
- Removing and installing camshaft – VW Golf Cabriolet · 47 torque figures
- Adjusting valve timing – VW Passat B5 · 83 torque figures
- Removing and installing camshafts – VW Passat B6 · 39 torque figures
- Removing and installing coolant pump · 53 torque figures
- Removing and installing coolant thermostat housing with thermostat · 2 torque figures
- Adjusting sunroof glass panel (height adjustment) · 2 torque figures
- Removing and installing alternator, 1.9 l TDI engine
- Removing and installing moulded headliner, Passat CC 2009► and CC 2010► · 1 torque figures
- Adjusting fixed rear door window – VW Passat CC / CC · 2 torque figures
Who makes these pages, and how
TorqFix was built by a mechanic — after a 2,700 km drive with five roadside repairs that no diagnostic tool could explain.
The figures on this page come from manufacturer workshop documentation and are shown as they are. The page is assembled automatically from that data — it is not written by an AI. The AI works in the chat, where it answers for your specific car. It writes nothing here.
Variants of the same model differ. Cross-check torque against the factory manual for your engine before final tightening.
Seen a figure that does not match your manual? Write to us — we correct it and note when. support@torqfix.com
The story behind TorqFix →Workshop data on this page last updated 20 Sep 2026.