Removing and installing accelerator module (Touran) — VW

🧭 Before you start

Fits: VW Touran I (1T, 2003–2015)

• Special tools named: T10297

🔧 Engine codes this applies to

🔩 Torque settings

Values can differ between engine variants — check the code stamped on your block.

ℹ️ Always cross-check the exact figure against your vehicle's factory manual before final tightening — a wrong torque can damage the engine. These values are extracted from workshop data and may not cover every variant or revision.

📐 65 workshop diagrams for AXW

Real factory drawings for this job — timing marks, bolt locations and routing. Locked in the free view.

📋 Procedure

1. Remove steering column cover (arrows).
2. Pull connector off accelerator module.
3. Pull off cover cap in upper area of accelerator module.
4. Remove securing bolt.
5. To remove accelerator module, push release tool T10269 (for right-hand drive models T10297) into openings provided to stop.

6. Pull out accelerator pedal module vertically.
7. Push wiring guide (1) and electrical connector (2) onto accelerator module.
8. Press accelerator module onto securing pins (6).
9. Insert centring pin (7) into hole in floor of vehicle.
10. Secure accelerator module with bolt (3), specified torque 10 Nm and fit cap (4). — 10 Nm (7.4 lb-ft)
11. Install steering column trim.

Other VW procedures

• Removing and installing flywheel · 3 torque figures
• Removing and installing front exhaust pipe with catalytic converter
• Removing and installing oil filter bracket – VW · 3 torque figures
• Emptying fuel tank if it is less than 3/4 full · 1 torque figures
• Removing and installing map-controlled engine cooling thermostat F265, engine code AXW, BLX, BHD, BLY, BLR, BMB
• Removing engine · 41 torque figures
• Removing and installing camshaft – VW Golf Cabriolet · 47 torque figures
• Adjusting valve timing – VW Passat B5 · 83 torque figures
• Removing and installing camshafts – VW Passat B6 · 39 torque figures
• Removing and installing coolant pump · 53 torque figures