Removing and installing accelerator pedal module: VW Touran I (BGU, BLF, BMM, BSE, …)
Step-by-step removing and installing accelerator pedal module for the VW Touran I: 13 steps, 2 torque figures.
Workshop procedure for VW — the exact step sequence and torque figures, straight from real workshop data.
🧭 Before you start
Fits: VW Touran I (1T, 2003–2015)
- Special tools named: T10297
🔩 Torque settings
Values can differ between engine variants — check the code stamped on your block.
| Torque | Fastener / step |
|---|---|
| 10 Nm (7.4 lb-ft) | Secure accelerator pedal module with bolt (3), specified torque |
| 9 Nm (6.6 lb-ft) | Secure accelerator pedal module with securing bolt (3 |
ℹ️ Always cross-check the exact figure against your vehicle's factory manual before final tightening — a wrong torque can damage the engine. These values are extracted from workshop data and may not cover every variant or revision.
📐 56 workshop diagrams for BGU
Real factory drawings for this job — timing marks, bolt locations and routing. Locked in the free view.
📋 Procedure
- Lever off cap using a screwdriver.
- Remove securing bolt beneath it.
- To remove accelerator pedal module, push release toolT 10269 (for right-hand drive vehicles T10297) into opening provided to stop.
- Pull connector off accelerator pedal module.
- Pull wiring guide off accelerator pedal module.
- Pull out accelerator pedal module vertically.
- Attach connector and wiring guide to accelerator pedal module.
- Press accelerator pedal module onto securing pins.
- Insert centring pin into hole in vehicle floor.
- Secure accelerator pedal module with securing bolt (3). Specified torque: 9 Nm — 9 Nm (6.6 lb-ft)
- Attach cap.
- Install steering column cover.
Ask TorqFix about your VW BGU — it answers with the exact sequence for that engine and the workshop drawing for each step. First question is free after a 20-second sign-up, no card.
Ask about your VW BGU — free → or sign up free to see the drawingsOther VW procedures
- Removing and installing camshaft timing chain · 29 torque figures
- Removing and installing timing chain and chain drive for oil pump · 22 torque figures
- Removing and installing high-pressure pump – VW Passat B8 · 16 torque figures
- E - Checking sender wheel installation position on crankshaft · 13 torque figures
- Installing engine · 9 torque figures
- Removing engine · 41 torque figures
- Removing and installing camshaft – VW Golf Cabriolet · 47 torque figures
- Adjusting valve timing – VW Passat B5 · 83 torque figures
- Removing and installing camshafts – VW Passat B6 · 39 torque figures
- Removing and installing coolant pump · 53 torque figures
Who makes these pages, and how
TorqFix was built by a mechanic — after a 2,700 km drive with five roadside repairs that no diagnostic tool could explain.
The figures on this page come from manufacturer workshop documentation and are shown as they are. The page is assembled automatically from that data — it is not written by an AI. The AI works in the chat, where it answers for your specific car. It writes nothing here.
Variants of the same model differ. Cross-check torque against the factory manual for your engine before final tightening.
Seen a figure that does not match your manual? Write to us — we correct it and note when. support@torqfix.com
The story behind TorqFix →Workshop data on this page last updated 20 Sep 2026.