Checking signal from clutch pedal switch: VW Passat B5 2.3 (AZX)

🧭 Before you start

Fits: VW Passat B5 (3B)

• Special tools named: V.A.G 1551, V.A.G 1552

🔧 Engine codes this applies to

📐 5 workshop diagrams for AZX

Real factory drawings for this job — timing marks, bolt locations and routing. Locked in the free view.

📋 Procedure

1. Connect fault reader V.A.G 1551 (V.A.G 1552). Then switch ignition on and select engine control unit with "“Address word”" 01. (Connect fault reader and select engine control unit )
2. Press keys 0 and 8 for function "“Read measured value block”" and confirm entry with Q key.
3. Press keys 0, 6 and 6 for "“Display group number 66”" and confirm entry with Q key.
4. Observe display in display zone 2. (6th position from left) Specification: x x x x x 0 x x
5. Fully depress clutch pedal and observe the display in display zone 2. Specification: x x x x x 1 x x

6. Press → button.
7. Press buttons 0 and 6 for function "“End output”" and confirm entry with Q button.
8. Switch off ignition.
9. Remove driver's storage compartment: General body repairs, interior68Dash panel; Removing driver's storage compartment.
10. Checking clutch pedal switch F36 and line connections according to current flow diagram:

Other VW procedures

• Checking Lambda probe and Lambda control after catalytic converter
• Checking control unit voltage supply – VW Passat B5 2.3 AZX
• Connecting the fault reader
• Checking speed signal – VW Passat B5
• Test solenoid valve 1 for activated charcoal filter
• Removing engine · 41 torque figures
• Removing and installing camshaft – VW Golf Cabriolet · 47 torque figures
• Adjusting valve timing – VW Passat B5 · 83 torque figures
• Removing and installing camshafts – VW Passat B6 · 39 torque figures
• Removing and installing coolant pump · 53 torque figures