Checking current draw of fuel pump G6, engine codes CFHC, CFHF, CFJA, CLCA, CFJB — VW
Checking current draw of fuel pump G6, engine codes CFHC, CFHF, CFJA, CLCA, CFJB on VW: 12 steps, engines CFHC, CFHF, CFJA, CFJB.
Workshop procedure for VW — the exact step sequence and torque figures, straight from real workshop data.
🧭 Before you start
Fits: VW Touran I (1T, 2003–2015)
- Special tools named: VAS 5565
- Renewed: fuel delivery unit
Don't miss
- Pickup clamp of hand-held multimeterV.A.G 1715 can also be connected to red terminal with lettering "“pickup clamp”" of test instrument adapter/DSO (5-pin)VAS 5565.
- The fuel pump is now activated for 30 seconds.
📋 Procedure
- Remove seats of the 2nd row of seats from the vehicle.
- Detach floor covering at rear and fold back General body repairs, interior70.
- Remove cover from fuel delivery unit.
- Pull connector (C) off flange.
- Connect test instrument adapter/DSO (5-pin)VAS 5565 to connector and fuel delivery unit.
- Connect pick-up clamp (A) to red terminal with lettering "“pick-up clamp”" for test instrument adapter/DSO (5-pin)VAS 5565. [Note: Pickup clamp of hand-held multimeterV.A.G 1715 can also be connected to red terminal with lettering "“pickup clamp”" of test instrument adapter/DSO (5-pin)VAS 5565.]
- Disconnect connector from supplementary fuel pump V393 or fuel pump 2V277(Inline EFP) in engine compartment.
- Switch on ignition.
- Connect diagnosis tester and perform the guided function "“Checking electric fuel pump(s)”". [Note: The fuel pump is now activated for 30 seconds.]
- Read current draw on hand-held multimeterV.A.G 1526D. Specification: max. 7.5 amps.
- If the measured value is not within specifications:
- Renew fuel delivery unit .
Other VW procedures
- Removing and installing reducing agent tank – VW CC 2.0 TDI
- Removing and installing pressure difference sender G5051
- Removing and installing fuel tank, four-wheel drive
- Removing and installing coolant temperature sender at radiator outlet G83
- Checking hydraulic compensation elements – VW Touareg II
- Removing engine · 41 torque figures
- Removing and installing camshaft – VW Golf Cabriolet · 47 torque figures
- Adjusting valve timing – VW Passat B5 · 83 torque figures
- Removing and installing camshafts – VW Passat B6 · 39 torque figures
- Removing and installing coolant pump · 53 torque figures
Who makes these pages, and how
TorqFix was built by a mechanic — after a 2,700 km drive with five roadside repairs that no diagnostic tool could explain.
The figures on this page come from manufacturer workshop documentation and are shown as they are. The page is assembled automatically from that data — it is not written by an AI. The AI works in the chat, where it answers for your specific car. It writes nothing here.
Variants of the same model differ. Cross-check torque against the factory manual for your engine before final tightening.
Seen a figure that does not match your manual? Write to us — we correct it and note when. support@torqfix.com
The story behind TorqFix →Workshop data on this page last updated 20 Sep 2026.