Brake disc - remove and install — VW
Brake disc - remove and install on VW: 4 steps, 1 torque figure. What to remove, what to tighten and to how many Nm, what to check after.
Workshop procedure for VW — the exact step sequence and torque figures, straight from real workshop data.
🧭 Before you start
Fits: platform codes 9A2, 9A4, 9A5, 9A1, 9A3, 9A6
🔩 Torque settings
Values can differ between engine variants — check the code stamped on your block.
| Torque | Fastener / step |
|---|---|
| 4 Nm (3.0 lb-ft) | Fasten the brake disc bolt with a torque |
ℹ️ Always cross-check the exact figure against your vehicle's factory manual before final tightening — a wrong torque can damage the engine. These values are extracted from workshop data and may not cover every variant or revision.
📋 Procedure
- Remove the wheel.
- Remove the brake caliper.
- Remove the brake disc by releasing the bolt (arrow).
- Fasten the brake disc bolt with a torque of 4 Nm. — 4 Nm (3.0 lb-ft)
Other VW procedures
- Removing engine · 41 torque figures
- Removing and installing camshaft – VW Golf Cabriolet · 47 torque figures
- Adjusting valve timing – VW Passat B5 · 83 torque figures
- Removing and installing camshafts – VW Passat B6 · 39 torque figures
- Removing and installing coolant pump · 53 torque figures
- Removing and installing anti-theft-secured engine control unit J623 (Passat 2006 ►)
- Removing and installing starter, vehicles with 2.0 l TDI engine and manual gearbox MQ500
- Removing and installing starter, vehicles with 2.0 l TSI engine and automatic gearbox AQ450
- Emptying the fuel tank (Autogas)
- Removing and installing high-level brake light, except for GTI
Who makes these pages, and how
TorqFix was built by a mechanic — after a 2,700 km drive with five roadside repairs that no diagnostic tool could explain.
The figures on this page come from manufacturer workshop documentation and are shown as they are. The page is assembled automatically from that data — it is not written by an AI. The AI works in the chat, where it answers for your specific car. It writes nothing here.
Variants of the same model differ. Cross-check torque against the factory manual for your engine before final tightening.
Seen a figure that does not match your manual? Write to us — we correct it and note when. support@torqfix.com
The story behind TorqFix →Workshop data on this page last updated 20 Sep 2026.