Removing and installing starter, vehicles with 2.0 l TDI engine and manual gearbox MQ500 — VW
Removing and installing starter, vehicles with 2.0 l TDI engine and manual gearbox MQ500 on VW: 15 steps.
Workshop procedure for VW — the exact step sequence and torque figures, straight from real workshop data.
🧭 Before you start
Fits: VW Tiguan I (5N, 2007–2016)
Don't miss
- When batteries are disconnected and reconnected, the procedure described in the workshop manual must be strictly observed . — Disconnect battery .
📋 Procedure
- ⚠ When batteries are disconnected and reconnected, the procedure described in the workshop manual must be strictly observed . — Disconnect battery .
- Pull engine cover panel upwards (arrows).
- Release and detach connector (1). Loosen spring-type clip (2) using spring-type clip pliersVAS 5024A and pull off vacuum hose (3).
- Remove securing bolt from air filter housing (arrow).
- Release locking lugs (arrows) and take off cover.
- Pull hose (arrow) off air filter housing and remove.
- Pull air filter housing upwards out of brackets and remove.
- Slide protective cap off solenoid switch in direction of (arrow).
- Unscrew positive wire (1) and disconnect connector from terminal 50 (2).
- Unscrew nuts (2) from securing bolts of starter and remove wiring retainer (1).
- Remove upper securing bolt of starter (arrow).
- Remove noise insulation General body repairs, exterior50Body - front; Noise insulation.
- Remove lower securing bolt of starter (arrow).
- Remove starter downwards out of vehicle.
- Tighten threaded connections to torques specified in assembly overview .
Other VW procedures
- Removing engine · 41 torque figures
- Removing and installing camshaft – VW Golf Cabriolet · 47 torque figures
- Adjusting valve timing – VW Passat B5 · 83 torque figures
- Removing and installing camshafts – VW Passat B6 · 39 torque figures
- Removing and installing coolant pump · 53 torque figures
- Removing mechatronic unit for dual clutch gearbox J743 with gearbox installed
- Removing and installing slave cylinder
- Removing upper sump – VW Passat B5 4.0 BDN/BDP · 1 torque figures
- Renewing seals for right flange shaft or stub shaft - front-wheel drive · 1 torque figures
- Removing and installing headlight (vehicles ▸ 09.00 – VW · 1 torque figures
Who makes these pages, and how
TorqFix was built by a mechanic — after a 2,700 km drive with five roadside repairs that no diagnostic tool could explain.
The figures on this page come from manufacturer workshop documentation and are shown as they are. The page is assembled automatically from that data — it is not written by an AI. The AI works in the chat, where it answers for your specific car. It writes nothing here.
Variants of the same model differ. Cross-check torque against the factory manual for your engine before final tightening.
Seen a figure that does not match your manual? Write to us — we correct it and note when. support@torqfix.com
The story behind TorqFix →Workshop data on this page last updated 20 Sep 2026.