Adjusting height of sunroof glass panel: VW Sharan I / SEAT Alhambra
Step-by-step adjusting height of sunroof glass panel for the VW Sharan I / SEAT Alhambra: 7 steps, 1 torque figure.
Workshop procedure for VW — the exact step sequence and torque figures, straight from real workshop data.
🧭 Before you start
Fits: VW Sharan I / SEAT Alhambra (7M)
🔩 Torque settings
Values can differ between engine variants — check the code stamped on your block.
| Torque | Fastener / step |
|---|---|
| 6 Nm (4.4 lb-ft) | Tighten screws for glass panel |
ℹ️ Always cross-check the exact figure against your vehicle's factory manual before final tightening — a wrong torque can damage the engine. These values are extracted from workshop data and may not cover every variant or revision.
📋 Procedure
- Tilt glass panel.
- Fully push back sliding headliner.
- Release trim frame and move towards rear.
- Move glass panel to zero position.
- To prevent wind noises carry out front and rear height adjustment in accordance with illustrations.
- Tighten screws for glass panel; specified torque 6 Nm. — 6 Nm (4.4 lb-ft)
- Slide trim frame forwards and clip in (secured with clips in area of front guides and guided in rear area by lugs).
Other VW procedures
- Removing engine · 41 torque figures
- Removing and installing camshaft – VW Golf Cabriolet · 47 torque figures
- Adjusting valve timing – VW Passat B5 · 83 torque figures
- Removing and installing camshafts – VW Passat B6 · 39 torque figures
- Removing and installing coolant pump · 53 torque figures
- Removing and installing telephone bracket R126
- Removing and installing lower coolant pipes – VW 2.0 CCZB
- Removing and installing gear knob – VW 2.0
- Removing and installing information electronics control unit 1J794
- 5-speed manual gearbox 02C, four-wheel drive — Renewing O-rings for rear final drive housing cover (final drive installed)
Who makes these pages, and how
TorqFix was built by a mechanic — after a 2,700 km drive with five roadside repairs that no diagnostic tool could explain.
The figures on this page come from manufacturer workshop documentation and are shown as they are. The page is assembled automatically from that data — it is not written by an AI. The AI works in the chat, where it answers for your specific car. It writes nothing here.
Variants of the same model differ. Cross-check torque against the factory manual for your engine before final tightening.
Seen a figure that does not match your manual? Write to us — we correct it and note when. support@torqfix.com
The story behind TorqFix →Workshop data on this page last updated 20 Sep 2026.