AdBlue renew BJL — VW

🧭 Before you start

Fits: platform codes 2.5, TDI

Don't miss

• Ensure the filling container is closed and lower than the additive tank before connecting

🔧 Engine codes this applies to

📋 Procedure

1. Clean the area and allow to dry before proceeding
2. Remove the AdBlue filler cap
3. Note: Ensure the filling container is closed and lower than the additive tank before connecting
4. Raise the filling container above the additive tank
5. Connect the filler pipe from the container to the additive tank

6. Open the filling container valve
7. Close the valve when fluid is escaping through the overflow pipe
8. Remove the filling and overflow container
9. Open the valve until the remaining fluid returns to the filling container
10. After refilling the tank
11. Wait for 2 minutes
12. Turn the ignition on

Other VW procedures

• Removing and installing filler line for reducing agent (panel van and window van)
• Removing and installing reducing agent tank (panel van and window van)
• Filling fuel system – Audi 2.5 TDI
• Removing and installing turbocharger (engine codes CEBA, CEBB, CECA, CECB)
• Emptying reducing agent tank (platform van and chassis)
• Removing engine · 41 torque figures
• Removing and installing camshaft – VW Golf Cabriolet · 47 torque figures
• Adjusting valve timing – VW Passat B5 · 83 torque figures
• Removing and installing camshafts – VW Passat B6 · 39 torque figures
• Removing and installing coolant pump · 53 torque figures