Removing and installing turbocharger (engine codes CEBA, CEBB, CECA, CECB) — AUDI

🧭 Before you start

Fits: platform codes 2EA, 2ED, 2EH, 2EX, 2EB, 2EE, 2EK, 2FC, 2FF, 2FL, 2FZ, 2FG, 2FM

• Renewed: turbocharger

🔧 Engine codes this applies to

📐 16 workshop diagrams for BJJ

Real factory drawings for this job — timing marks, bolt locations and routing. Locked in the free view.

📋 Procedure

1. ⚠ When mechanical damage is found on the turbocharger, e.g. a destroyed compressor impeller, it is not only sufficient to renew the turbocharger. To prevent this from causing further damage, perform the following repairs:Check air filter housing, air filter element and intake hoses for soiling.Check complete charged air routing and charge air cooler for foreign objects.If foreign objects are found in the charge air system, the charged air routing must be cleaned and the charge air cooler must be renewed, if necessary. — With the ignition switched off, disconnect battery earth strap 27.
2. Remove heater air duct.
3. Remove intake hose .
4. Pull off vacuum hose and connector from turbocharger (arrows).
5. Remove air intake hose (3).

6. Remove support (2) from turbocharger. Only loosen securing bolt on engine bracket.
7. Remove clamp (1).
8. Remove oil return line at cylinder block.
9. Remove oil supply line at oil filter bracket.
10. Unscrew turbocharger from exhaust manifold.

Other AUDI procedures

• Removing and installing valve stem seals
• Removing and installing fuel metering valve N290 – Audi BJJ
• Bleeding fuel system – Audi A4 Cabriolet B6/B7 / A4 B6/B7
• Separating plug-in connectors
• Removing and installing engine control unit J623 – Audi
• Removing and installing toothed belt – Audi · 56 torque figures
• Removing engine – Audi A8 D3 · 41 torque figures
• Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
• Installing engine – Audi A8 D4 · 36 torque figures
• Removing and installing camshaft timing chain · 29 torque figures