Removing and installing filler line for reducing agent (panel van and window van) — AUDI

🧭 Before you start

Fits: platform codes 2EA, 2ED, 2EH, 2EX, 2EB, 2EE, 2EK, 2FC, 2FF, 2FL, 2FZ, 2FG, 2FM

🔧 Engine codes this applies to

📐 16 workshop diagrams for BJJ

Real factory drawings for this job — timing marks, bolt locations and routing. Locked in the free view.

📋 Procedure

1. ⚠ The reducing agent can irritate skin, eyes and respiratory organs.After skin contact with this agent, wash immediately with plenty of water.If necessary seek advice from a doctor. — Emptying tank for reducing agent .
2. Remove front right wheel housing liner 66.
3. Remove step insert (right-side) 68.
4. Remove door storage compartment.
5. ⚠ Immediately seal all openings and connections using suitable plugs to stop ingress of dirt. — Unfasten screw-type clip (3) and pull connecting hose (2) off reducing agent tank.

6. Push securing clip (arrow B) together and pull off filler line.
7. Remove plug and connect filler line to reducing agent tank and to filler neck.
8. Press filler line into its clips.
9. Install door storage compartment.
10. Install step insert (right-side) 68.
11. Install front right wheel housing liner 66.
12. Fill reducing agent tank 10.2.

Other AUDI procedures

• Removing and installing camshaft – Audi A6/A7 C7 · 15 torque figures
• Removing and installing high-pressure pump · 8 torque figures
• Removing and installing fuel tank – Audi Q3
• Removing and installing oil sump · 2 torque figures
• Removing and installing fuel pressure regulating valve N276 · 3 torque figures
• Removing and installing toothed belt – Audi · 56 torque figures
• Removing engine – Audi A8 D3 · 41 torque figures
• Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
• Installing engine – Audi A8 D4 · 36 torque figures
• Removing and installing camshaft timing chain · 29 torque figures