Remove Demio cylinder head — MAZDA

🧭 Before you start

Fits: platform codes 1.3, 16V, |, 1.5

🔧 Engine codes this applies to

📐 25 workshop diagrams for B3

Real factory drawings for this job — timing marks, bolt locations and routing. Locked in the free view.

📋 Procedure

1. Remove the front exhaust pipe
2. Remove the air filter and the air inlet hose
3. Coolant pump pulley bolts
4. Crankshaft pulley:
5. Refit the valve cover

6. Installation sequence:
7. Further refitting is in the reverse order of removal
8. Note: Plug the ends of the fuel lines
9. Remove the radiator upper hose
10. Remove the coolant pump pulley
11. Remove the crankshaft pulley outer bolts
12. Remove the plate
13. Remove the timing belt upper cover
14. Remove the timing belt lower cover
15. Remove the timing belt
16. Remove the exhaust manifold heat shield
17. Remove the inlet manifold bracket
18. Disconnect the heater hose
19. Remove the valve cover
20. In the reverse order to that shown
21. Remove the cylinder head bolts
22. In the reverse order to that shown
23. Remove the cylinder head

Other MAZDA procedures

• Remove MPV GY cylinder head – Mazda GY
• Mazda 6, F3 timing chain replacement
• Mazda 6 Turbo 2.0 diesel timing belt replacement
• Mazda 3 2003 L3/LF timing chain replacement
• Mazda RF timing belt replacement
• Mazda 3 BK RF timing belt replacement
• Mazda 2_Demio 2007 ZJ/ZY timing chain replacement
• Mazda 6 2.2 2008 R2 timing chain replacement
• Mazda 6 2007 timing chain replacement
• Mazda Tribute 3.0 V6 DURATECAJ timing chain replacement