TorqFix

Timing chain replacement: Ford Scorpio 2.0 16 V '95> (N3A, NSD)

Step-by-step timing chain replacement for the Ford Scorpio 2.0 16 V '95> (N3A/NSD): 62 steps. What to remove, in what order, and what to check after.

Workshop procedure for FORD — the exact step sequence and torque figures, straight from real workshop data.

62 steps 2 engine codes

🧭 Before you start

Fits: platform codes 2.0I, |, 16V

  • Timing position: the crankshaft or camshaft is set and locked during this job
  • Special tools named: locking tool

Don't miss

  • Never turn the engine in the direction opposite to that of normal operation
  • Caution! Do not re-use the removed part

🔧 Engine codes this applies to

📋 Procedure

  1. Flywheel locking tool:
  2. Unless otherwise advised by the manufacturer, the following procedures are recommended:
  3. Further refitting is in the reverse order of removal
  4. Remove the engine lower cover
  5. Never turn the engine in the direction opposite to that of normal operation
N3A? Steps differ between engine variants — check this job against your exact car before you commit to it. Check my car — free →
  1. Stage 1:
  2. Stage 2:
  3. Disconnect the oil temperature sensor
  4. Starter motor:
  5. Turn the crankshaft to TDC for cylinder 4
  6. Check the timing marks
  7. Fit the timing chain lower cover
  8. Caution! Do not re-use the removed part
  9. Stage 2:
  10. Remove the crankcase breather hose
  11. Disconnect the EGR system
  12. Remove the valve cover
  13. Remove the timing belt upper cover
  14. Align the timing marks
  15. Remove the chain guide(s)
  16. Loosen the camshaft gearwheels
  17. Remove the timing chain from the camshaft gearwheel
  18. Remove the camshaft gearwheels
  19. Remove the tensioner lever
  20. Remove the chain guide(s)
  21. Remove the tensioner
  22. Remove the alternator belt
  23. Remove the starter motor
  24. Use a special tool to lock the crankshaft
  25. Remove the crankshaft pulley
  26. Remove the timing chain cover
  27. Remove the oil pump gearwheel
  28. Remove the timing chain

Who makes these pages, and how

TorqFix was built by a mechanic — after a 2,700 km drive with five roadside repairs that no diagnostic tool could explain.

The figures on this page come from manufacturer workshop documentation and are shown as they are. The page is assembled automatically from that data — it is not written by an AI. The AI works in the chat, where it answers for your specific car. It writes nothing here.

Variants of the same model differ. Cross-check torque against the factory manual for your engine before final tightening.

Seen a figure that does not match your manual? Write to us — we correct it and note when. support@torqfix.com

The story behind TorqFix →

Workshop data on this page last updated 20 Sep 2026.