TorqFix

Gearbox removal & installation: Citroen C4 Picasso MCP (DV6C, DV6DTED)

Step-by-step gearbox removal & installation for the Citroen C4 Picasso MCP (DV6C/DV6DTED): 20 steps. What to remove, in what order, and what to check.

Workshop procedure for CITROEN — the exact step sequence and torque figures, straight from real workshop data.

20 steps 3 engine codes

🔧 Engine codes this applies to

DV6C(9HC)DV6C(9HR)DV6DTED(9HP)

📋 Procedure

  1. Starter motor
  2. Handle:
  3. Use a diagnostic tool
  4. Disconnect the battery
  5. Raise the vehicle
DV6C(9HC)? Steps differ between engine variants — check this job against your exact car before you commit to it. Check my car — free →
  1. Remove the engine together with the gearbox
  2. Remove the nut
  3. Remove the stud
  4. Remove the bolt
  5. Protect the gear-shift hydraulic unit
  6. Use the special tool
  7. Use a hoist to support the gearbox
  8. Remove the engine/gearbox lower attaching bolts
  9. Remove the engine/gearbox upper attaching bolts
  10. Remove the gearbox

Other CITROEN procedures

Who makes these pages, and how

TorqFix was built by a mechanic — after a 2,700 km drive with five roadside repairs that no diagnostic tool could explain.

The figures on this page come from manufacturer workshop documentation and are shown as they are. The page is assembled automatically from that data — it is not written by an AI. The AI works in the chat, where it answers for your specific car. It writes nothing here.

Variants of the same model differ. Cross-check torque against the factory manual for your engine before final tightening.

Seen a figure that does not match your manual? Write to us — we correct it and note when. support@torqfix.com

The story behind TorqFix → · How these pages are made →

Workshop data on this page last updated 20 Sep 2026.