TorqFix

Berlingo DV6 hydraulic power steering ancillary belt — CITROEN

Berlingo DV6 hydraulic power steering ancillary belt on Citroen: 17 steps, engines DV6C(9HL), DV6C(9HR), DV6CM(9HG), DV6DTED(9HE).

Workshop procedure for CITROEN — the exact step sequence and torque figures, straight from real workshop data.

17 steps 8 engine codes

🧭 Before you start

Fits: platform codes 1.6, HDI, 75, |, 90, HDIF, 110, 115, 92

  • Timing position: the crankshaft or camshaft is set and locked during this job
  • Special tools named: locking pin

🔧 Engine codes this applies to

DV6C(9HL)DV6C(9HR)DV6CM(9HG)DV6DTED(9HE)DV6DTED(9HF)DV6DTED(9HP)DV6ETED(9HN)DV6TED4(9HZ)

📋 Procedure

  1. Vehicles without air conditioning:
  2. Fit the ancillary drive belt
  3. Wrench:
  4. Remove the front right wheel
  5. Refit the front splash guard
DV6C(9HL)? Steps differ between engine variants — check this job against your exact car before you commit to it. Check my car — free →
  1. Refit the engine lower cover
  2. Turn the tensioner pulley clockwise
  3. Use a wrench
  4. Lock the tensioner; use a locking pin
  5. Remove the ancillary drive belt

Other CITROEN procedures

Who makes these pages, and how

TorqFix was built by a mechanic — after a 2,700 km drive with five roadside repairs that no diagnostic tool could explain.

The figures on this page come from manufacturer workshop documentation and are shown as they are. The page is assembled automatically from that data — it is not written by an AI. The AI works in the chat, where it answers for your specific car. It writes nothing here.

Variants of the same model differ. Cross-check torque against the factory manual for your engine before final tightening.

Seen a figure that does not match your manual? Write to us — we correct it and note when. support@torqfix.com

The story behind TorqFix →

Workshop data on this page last updated 20 Sep 2026.