RS6 (4F) BUH ancillary drive belt — AUDI

🧭 Before you start

Fits: platform code RS6

Don't miss

• At removal, mark the direction of rotation; when refitting ensure the drive belt rotates in the same direction

🔧 Engine codes this applies to

📋 Procedure

1. Remove the front bumper cover
2. Remove the cover
3. Remove the bolt
4. Note: Do not disconnect
5. Remove the bolt

6. Note: Do not disconnect
7. Disconnect the electrical connector
8. Note: Do not disconnect
9. Disconnect the electrical connector
10. Note: Do not disconnect
11. Disconnect the electrical connector
12. Remove the bolts
13. Remove the cover
14. Loosen the bolts
15. Note: Do not remove
16. Loosen the bolts
17. Note: Do not remove
18. Remove the nuts
19. On both sides
20. Disconnect the power steering oil cooler hose
21. Secure to the vehicle
22. Turn the special tool clockwise
23. Torx:
24. Turn the tensioner anti-clockwise
25. Remove the ancillary drive belt
26. Note: At removal, mark the direction of rotation; when refitting ensure the drive belt rotates in the same direction

Other AUDI procedures

• Checking oil pressure switch F1 – Audi A6 C6
• Installing oil return line with oil reservoir – Audi A6 C6 5.0
• Checking combination valves for secondary air system for correct operation and leakage
• Renewing oil seal for AC compressor drive – Audi R8
• Removing and installing engine control units J623 / J624
• Removing and installing toothed belt – Audi · 56 torque figures
• Removing engine – Audi A8 D3 · 41 torque figures
• Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
• Installing engine – Audi A8 D4 · 36 torque figures
• Removing and installing camshaft timing chain · 29 torque figures