TT_3.2 BHE/BPF Ancillary drive belt — AUDI
TT_3.2 BHE/BPF Ancillary drive belt on Audi: 10 steps, engines BHE, BPF. What to remove, in what order, and what to check after.
Workshop procedure for AUDI — the exact step sequence and torque figures, straight from real workshop data.
🧭 Before you start
Fits: platform codes 3.2, V6
Don't miss
- Mark the running direction of the ancillary drive belt with chalk
📋 Procedure
- Refit the ancillary drive belt
- Remove the cover
- Remove the bolt
- Refit all parts in the reverse order of removal
- Remove the ancillary drive belt
- Mark the running direction of the ancillary drive belt with chalk
Other AUDI procedures
- Adjusting engine mountings – Audi A3
- Removing and installing Lambda probes (before catalytic converter)
- Removing and installing ignition coils – Audi A8 D3
- Renewing crankshaft oil seal (vibration damper end) – Audi BHE
- Checking fuel pump delivery rate – Audi A8 D3
- Removing and installing toothed belt – Audi · 56 torque figures
- Removing engine – Audi A8 D3 · 41 torque figures
- Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
- Installing engine – Audi A8 D4 · 36 torque figures
- Removing and installing camshaft timing chain · 29 torque figures
Who makes these pages, and how
TorqFix was built by a mechanic — after a 2,700 km drive with five roadside repairs that no diagnostic tool could explain.
The figures on this page come from manufacturer workshop documentation and are shown as they are. The page is assembled automatically from that data — it is not written by an AI. The AI works in the chat, where it answers for your specific car. It writes nothing here.
Variants of the same model differ. Cross-check torque against the factory manual for your engine before final tightening.
Seen a figure that does not match your manual? Write to us — we correct it and note when. support@torqfix.com
The story behind TorqFix →Workshop data on this page last updated 20 Sep 2026.