Removing and installing upper B-pillar trim, kombi — AUDI
Removing and installing upper B-pillar trim, kombi on Audi: 17 steps. What to remove, in what order, and what to check after.
Workshop procedure for AUDI — the exact step sequence and torque figures, straight from real workshop data.
🧭 Before you start
Fits: VW Caddy III (2K, 2004–2015); platform code 2C0
- Renewed: if necessary
Don't miss
- Removal and installation is described for right side of vehicle. Removal and installation of the left vehicle side is similar.
- Removal and installation are described for the left vehicle side.
- Before installing, check fasteners for damage and renew if necessary.Following installation, ensure that trim is positioned in door seal moulding.
📋 Procedure
- Switch off ignition.
- Remove light and switch unit from storage compartment 96.
- Remove roof grab handles .
- Remove sun visors .
- Remove roof gallery storage compartment .
- Remove light (if fitted) from upper B-pillar trim 96.
- Remove fixed partition .
- Remove lower B-pillar trim, Kombi . [Note: Removal and installation is described for right side of vehicle. Removal and installation of the left vehicle side is similar.]
- If fitted, remove coat hook .
- Fold cover cap (1) for seat belt relay (3) out upwards and remove bolt (2).
- Release seat belt relay from height adjuster.
- Pull trim out of mountings in body and from door seal moulding. [Note: Removal and installation are described for the left vehicle side.]
- If fitted, remove coat hook .
- Fold cover cap (1) for seat belt relay (3) out upwards and remove bolt (2).
- Release seat belt relay from height adjuster.
- Unscrew plastic pin (4) and remove spreader rivet (5).
- Pull trim out of mountings in body and from door seal moulding. [Note: Before installing, check fasteners for damage and renew if necessary.Following installation, ensure that trim is positioned in door seal moulding.]
Other AUDI procedures
- Removing and installing toothed belt – Audi · 56 torque figures
- Removing engine – Audi A8 D3 · 41 torque figures
- Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
- Installing engine – Audi A8 D4 · 36 torque figures
- Removing and installing camshaft timing chain · 29 torque figures
- Removing and installing trim panel for dash panel
- Removing and installing lower seat pan frame - front seat with electric adjustment
- Removing and installing seat pan cover and padding - standard seat/folding seat
- Removing and installing earth cable with battery monitor control unit J367, battery in engine compartment (version 2)
- Removing and installing starter - vehicles with 2.5 ltr. TFSI engine and dual clutch gearbox
Who makes these pages, and how
TorqFix was built by a mechanic — after a 2,700 km drive with five roadside repairs that no diagnostic tool could explain.
The figures on this page come from manufacturer workshop documentation and are shown as they are. The page is assembled automatically from that data — it is not written by an AI. The AI works in the chat, where it answers for your specific car. It writes nothing here.
Variants of the same model differ. Cross-check torque against the factory manual for your engine before final tightening.
Seen a figure that does not match your manual? Write to us — we correct it and note when. support@torqfix.com
The story behind TorqFix →Workshop data on this page last updated 20 Sep 2026.