Removing and installing seat pan cover and padding - standard seat/folding seat — AUDI

🧭 Before you start

Fits: Audi Q3 (8U, 2011–2018); platform code 84

📋 Procedure

1. ⚠ Observe safety regulations for pyrotechnic components .Before handling pyrotechnic components (e.g. unplugging the electrical connector) the mechanic must discharge any static electricity. This can be done by briefly touching the door striker plate, or similar. — Remove front seat .
2. Attach front seat to seat repair standVAS 6136.
3. Remove backrest .
4. Equipment version with front passenger seat with child seat anchor: Remove child seat anchor .
5. Equipment version with drawer: Remove drawer .

6. Equipment version with storage compartment: Remove storage compartment .
7. Remove seat side trim (sill side) with bracket:
8. Unplug electrical connectors and move clear.
9. Disengage piping (1) of seat cover using front-end hook3370 (front and side sections) (arrow).
10. Disengage piping (2) of seat cover using front-end hook3370 (rear section).
11. Detach seat cover with padding from seat pan and at the same time move clear wiring harness for seat heating and seat occupied sensor (if fitted).

Other AUDI procedures

• Removing and installing toothed belt – Audi · 56 torque figures
• Removing engine – Audi A8 D3 · 41 torque figures
• Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
• Installing engine – Audi A8 D4 · 36 torque figures
• Removing and installing camshaft timing chain · 29 torque figures
• Adjusting wheel bearing play, vehicles with twin wheels
• Removing and installing rubber bush and rear bracket of transfer box
• Renewing output shaft seal
• Removing and installing poly V-belt for viscous fan
• Removing and installing Y-thermostat .