Removing and installing earth cable with battery monitor control unit J367, battery in engine compartment (version 2) — AUDI

🧭 Before you start

Fits: Audi Q3 (8U, 2011–2018); platform code 84

📋 Procedure

1. Switch off ignition.
2. Versions equipped with ignition lock: Remove ignition key.
3. Remove air cleaner housing 23Air cleaner; Removing and installing air cleaner housing or 24Air cleaner; Removing and installing air cleaner housing.
4. Press the release tab (1) and swivel the battery cover (2) upwards; this disengages the guides at the mountings (3, 4) for the battery trim cover (rear).
5. Remove bolts (arrows).

6. Pull off battery trim cover (front) (item 1) upwards.
7. Pull off cover (4) over negative battery terminal.
8. Slacken off nut several turns and disconnect battery clamp (3) of earth cable from battery terminal.
9. Unplug electrical connector (1).
10. Remove nut (6) and detach earth cable (5) with battery monitor control unit J367(item 2).
11. Connect battery .

Other AUDI procedures

• Removing and installing toothed belt – Audi · 56 torque figures
• Removing engine – Audi A8 D3 · 41 torque figures
• Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
• Installing engine – Audi A8 D4 · 36 torque figures
• Removing and installing camshaft timing chain · 29 torque figures
• Performing zero compensation of steering angle sender G85
• Checking for contamination of throttle valve – Audi A3 1.8
• Servicing air spring strut – Audi A8 D4
• Removing and installing front bumper as of Model Year 2006
• Removing and installing CD changer - Roadster – Audi TT Mk1 · 1 torque figures