Removing and installing earth cable with battery monitor control unit J367 in luggage compartment — AUDI

🧭 Before you start

Fits: Audi A3 (8P, 2003–2012)

📋 Procedure

1. Switch off ignition and take out ignition key.
2. Take out rear moulded insert (3) for tools from under luggage compartment floor.
3. Take out front moulded insert (left-side) (1).
4. Release securing strap (3) and take out front moulded insert (2) for tools (right-side).
5. Unscrew cover (arrow) for battery compartment.

6. Detach moulded cover above battery.
7. Slacken off nut several turns and disconnect battery clamp (4) of earth cable from battery terminal.
8. Unplug electrical connector (3).
9. Remove nut (1) and detach earth cable (2) with battery monitor control unit J367(item 5).
10. Connect battery .

Other AUDI procedures

• Removing and installing toothed belt – Audi · 56 torque figures
• Removing engine – Audi A8 D3 · 41 torque figures
• Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
• Installing engine – Audi A8 D4 · 36 torque figures
• Removing and installing camshaft timing chain · 29 torque figures
• Removing and installing cover for rear wheel housing (Allroad)
• Removing rear spoiler – Audi A6 C5
• Checking continued coolant circulation relay J151 – Audi BCY
• Removing and installing manual window regulator – Audi · 1 torque figures
• Checking fuel pump delivery rate - vehicles with 1.8 ltr. turbo engine