Removing and installing earth cable with battery monitor control unit J367 - battery in luggage compartment — AUDI

🧭 Before you start

Fits: Audi A3 (8V, 2012–2020); platform code 85

📋 Procedure

1. Switch off ignition.
2. Versions equipped with mechanical ignition lock: Remove ignition key.
3. Versions equipped with electronic ignition lock: Deposit ignition key outside of vehicle.
4. Raise luggage compartment floor.
5. Remove tool box with tools.

6. Open cover (2) over negative battery terminal.
7. Slacken off nut (1) several turns and disconnect battery clamp of earth cable from battery terminal.
8. Unplug electrical connector (3).
9. Remove nut (4) and detach earth cable (5) with battery monitor control unit J367(item 6).
10. Connect battery .

Other AUDI procedures

• Removing and installing toothed belt – Audi · 56 torque figures
• Removing engine – Audi A8 D3 · 41 torque figures
• Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
• Installing engine – Audi A8 D4 · 36 torque figures
• Removing and installing camshaft timing chain · 29 torque figures
• Removing and installing condenser – Audi A6 C6 · 2 torque figures
• Removing and installing subframe, front-wheel drive vehicles · 1 torque figures
• Removing gearbox - vehicles with 2.0 ltr. TFSI engine (generation III)
• Draining and filling cooling system - engine cooling system
• Removing and installing rear axle (multi-link suspension - front-wheel drive vehicles) · 1 torque figures