Removing and installing starter - vehicles with 2.5 ltr. TFSI engine and dual clutch gearbox — AUDI

🧭 Before you start

Fits: Audi Q3 (8U, 2011–2018); platform code 84

📋 Procedure

1. Disconnect earth cable from battery with ignition switched off .
2. Remove air cleaner housing 24Air cleaner; Removing and installing air cleaner housing.
3. Unplug connector (4) by sliding locking element to rear and pressing down release catch.
4. Press off cap (3).
5. Unscrew wire for terminal 30/B+ (1) from alternator.

6. Remove centre hex stud (2).
7. Remove nut (6) and detach bracket (5) for earth cable.
8. Remove nut (1) and move clear earth cable (3).
9. Remove centre hex stud (2) and lift out starter (4) to front.
10. Install air cleaner housing 24Air cleaner; Removing and installing air cleaner housing.
11. Connect battery. Steps required .

Other AUDI procedures

• Removing and installing toothed belt – Audi · 56 torque figures
• Removing engine – Audi A8 D3 · 41 torque figures
• Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
• Installing engine – Audi A8 D4 · 36 torque figures
• Removing and installing camshaft timing chain · 29 torque figures
• Removing and installing front wheel speed sensor – Audi · 2 torque figures
• Removing gearbox - vehicles with 2.4 ltr. MPI or 2.8 ltr./3.2 ltr. FSI engine · 1 torque figures
• Removing and installing rear shelf with sun blind (rear)
• Removing and installing seat adjustment switch – Audi A6 C6 · 3 torque figures
• Removing and installing motor 1 for rear lid V444 / motor 2 for rear lid V445