Removing and installing starter - Audi TT with 2.0 ltr. TFSI engine and dual clutch gearbox 02E — AUDI

🧭 Before you start

Fits: Audi TT Mk2 (8J, 2006–2014)

Don't miss

• Disregard (item 4).

📋 Procedure

1. With ignition switched off, disconnect earth cable at battery .
2. Remove air cleaner housing 24Air cleaner; Removing and installing air cleaner housing.
3. Remove cable tie (arrow) for protective sleeve.
4. Unplug electrical connector (2).
5. Fold back protective sleeve (1) and detach B+ wire from solenoid switch.

6. Unscrew earth cable (3).
7. Remove lower starter bolt (accessible from above).
8. Remove upper starter bolt and detach starter. [Note: Disregard (item 4).]
9. Install air cleaner housing 24Air cleaner; Exploded view - air cleaner housing.
10. Connect battery. Steps required .

Other AUDI procedures

• Removing and installing toothed belt – Audi · 56 torque figures
• Removing engine – Audi A8 D3 · 41 torque figures
• Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
• Installing engine – Audi A8 D4 · 36 torque figures
• Removing and installing camshaft timing chain · 29 torque figures
• Exploded view of crankshaft · 4 torque figures
• Removing and installing top part of sump – Audi A8 D2 3.3 TDI · 2 torque figures
• Removing and installing (up to model year 2005/RSE) – Audi · 3 torque figures
• Sealing upper and lower covers · 3 torque figures
• Removing and installing fuel tank, natural gas – Audi 2.0 BSX · 1 torque figures