Removing and installing starter - vehicles with 1.4 ltr. TFSI engine and dual clutch gearbox — AUDI

🧭 Before you start

Fits: Audi A3 (8P, 2003–2012)

📋 Procedure

1. Release retainers (arrows) at the sides and pull off cover (1) for air duct.
2. Release retainers (arrows) and unclip air duct (bottom).
3. Detach air duct (bottom) together with air hose.
4. Release hose clip and detach air hose (1) from turbocharger.
5. Detach vacuum hose (2).

6. Unscrew bolt (3) and detach air cleaner housing.
7. Remove battery mounting .
8. Unplug electrical connector (2).
9. Fold back protective sleeve (1) and detach "“B+”" wire from solenoid switch.
10. Remove bolt (3) for earth cable.
11. Remove lower and upper starter securing bolts.
12. Take out starter.
13. Install battery mounting .
14. Connect battery. Steps required .

Other AUDI procedures

• Removing and installing toothed belt – Audi · 56 torque figures
• Removing engine – Audi A8 D3 · 41 torque figures
• Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
• Installing engine – Audi A8 D4 · 36 torque figures
• Removing and installing camshaft timing chain · 29 torque figures
• Removing and installing rear axle with mounting bracket – Audi · 1 torque figures
• Replacing oil seals for rear axle shafts · 1 torque figures
• Removing backrest cover and padding · 3 torque figures
• Connecting wiring harnesses 8E1 970 XXX to multi-pin connector for airbag control unit J234
• Checking secondary air pump relay J299 and secondary air pump motor V101