Removing and installing starter - Audi TT RS with 2.5 ltr. TFSI engine and dual clutch gearbox — AUDI

🧭 Before you start

Fits: Audi TT Mk2 (8J, 2006–2014)

📋 Procedure

1. With ignition switched off, disconnect earth cable at battery .
2. Remove air cleaner housing 24Air cleaner; Exploded view - air cleaner housing.
3. Unplug connector (4) by sliding locking element to rear and pressing down release catch.
4. Fold back protective sleeve (3) and detach B+ wire (item 1) from solenoid switch.
5. Remove centre hex stud (2).

6. Remove nut (6) and detach bracket (5) for earth cable.
7. Remove nut (1) and move clear earth cable (3).
8. Remove centre hex stud (2) and lift out starter (4) to front.
9. Install air cleaner housing 24Air cleaner; Exploded view - air cleaner housing.
10. Connect battery. Steps required .

Other AUDI procedures

• Removing and installing toothed belt – Audi · 56 torque figures
• Removing engine – Audi A8 D3 · 41 torque figures
• Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
• Installing engine – Audi A8 D4 · 36 torque figures
• Removing and installing camshaft timing chain · 29 torque figures
• Removing and installing backrest centre section – Audi A8 D3 · 1 torque figures
• Removing and installing convertible top compartment lid – Audi
• 5 and 6-speed manual gearbox 01E, front-wheel drive — Renewing oil seal for flange shaft
• Checking exhaust gas recirculation valve N18 - vehicles with engine code letters AJM
• Removing and installing glove box locking mechanism – Audi · 1 torque figures