Removing and installing trim panel for dash panel — AUDI
Removing and installing trim panel for dash panel on Audi: 11 steps. What to remove, in what order, and what to check after.
Workshop procedure for AUDI — the exact step sequence and torque figures, straight from real workshop data.
🧭 Before you start
Fits: platform codes SF, SG
📋 Procedure
- Remove dash panel vent on front passenger side .
- Using wedge T10039/1, unclip trim panel (1) in (direction of arrow) from catches.
- Fit trim panel in installation position, and press it on until catches can be heard to engage.
- Remove dash panel vent on driver side .
- Using wedge T10039/1, unclip trim panel (1) in (direction of arrow) from catches.
- Fit trim panel in installation position, and press it on until catches can be heard to engage.
- Using wedge T10039/1, unclip trim panel (1) in (direction of arrow) from catches.
- Fit trim panel in installation position, and press it on until catches can be heard to engage.
- Using wedge T10039/1 and starting at position (2), unclip trim panel (1) in (direction of arrow) from catches.
- Fit trim panel in installation position, and press it on until catches can be heard to engage.
Other AUDI procedures
- Removing and installing toothed belt – Audi · 56 torque figures
- Removing engine – Audi A8 D3 · 41 torque figures
- Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
- Installing engine – Audi A8 D4 · 36 torque figures
- Removing and installing camshaft timing chain · 29 torque figures
- Checking Servotronic solenoid valve – Audi
- Replacing bonded rubber bushes for subframe (steel) – Audi
- Removing and installing window frame, fixed door window – Audi
- Removing and installing door window, fixed door window – Audi
- Renewing encoder ring – Audi A8 D4
Who makes these pages, and how
TorqFix was built by a mechanic — after a 2,700 km drive with five roadside repairs that no diagnostic tool could explain.
The figures on this page come from manufacturer workshop documentation and are shown as they are. The page is assembled automatically from that data — it is not written by an AI. The AI works in the chat, where it answers for your specific car. It writes nothing here.
Variants of the same model differ. Cross-check torque against the factory manual for your engine before final tightening.
Seen a figure that does not match your manual? Write to us — we correct it and note when. support@torqfix.com
The story behind TorqFix →Workshop data on this page last updated 20 Sep 2026.