Removing and installing starter - vehicles with 3.0 ltr. TFSI engine — AUDI

🧭 Before you start

Fits: Audi A6/A7 C7 (4G, 2011–2018); platform code 4X

Don't miss

• Disregard (items 2, 4, 5, 6).

📋 Procedure

1. Disconnect earth cable from battery with ignition switched off .
2. Remove plenum chamber partition panel General body repairs, exterior50Bulkhead; Removing and installing plenum chamber partition panel.
3. Remove bolt (arrow).
4. Unplug electrical connector (1) at oil level and oil temperature sender G266.
5. Move clear wiring harness (3) at alternator (arrows). [Note: Disregard (items 2, 4, 5, 6).]

6. Remove engine mountings 10Assembly mountings; Removing and installing engine mountings.
7. Remove nut (1) and move earth cable clear at engine support.
8. Remove bolts (arrows) and detach engine support (right-side).
9. Unplug connector (3) by sliding locking element to rear and pressing down release catch.
10. Unscrew nut (4) and detach B+ wire (2) from solenoid switch.
11. Remove bolt (5) and detach starter (1).
12. Connect battery. Steps required .

Other AUDI procedures

• Removing and installing toothed belt – Audi · 56 torque figures
• Removing engine – Audi A8 D3 · 41 torque figures
• Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
• Installing engine – Audi A8 D4 · 36 torque figures
• Removing and installing camshaft timing chain · 29 torque figures
• Removing and installing four-way lumber support - vehicles up to model year 2005
• Removing and installing remote release motor – Audi A6 C5 · 1 torque figures
• Removing and installing cover for rear wheel housing (Allroad)
• Removing rear spoiler – Audi A6 C5
• Checking continued coolant circulation relay J151 – Audi BCY