Removing and installing remote release motor: Audi A6 C5
Step-by-step removing and installing remote release motor for the Audi A6 C5: 3 steps, 1 torque figure.
Workshop procedure for AUDI — the exact step sequence and torque figures, straight from real workshop data.
🧭 Before you start
Fits: Audi A6 C5 (4B)
Don't miss
- Operating rod (4) need not be unclipped from hinged lever (5).Prior to installation in rear lid, connector must be plugged in at motor.
🔩 Torque settings
Values can differ between engine variants — check the code stamped on your block.
| Torque | Fastener / step |
|---|---|
| 1.2 Nm (0.9 lb-ft) | Unscrew |
ℹ️ Always cross-check the exact figure against your vehicle's factory manual before final tightening — a wrong torque can damage the engine. These values are extracted from workshop data and may not cover every variant or revision.
📋 Procedure
- Unclip operating rod (3).
- Unscrew (1.2 Nm) bolts (2) (2x). — 1.2 Nm (0.9 lb-ft)
- Unplug connector from remote release motor (1). [Note: Operating rod (4) need not be unclipped from hinged lever (5).Prior to installation in rear lid, connector must be plugged in at motor.]
Other AUDI procedures
- Removing and installing toothed belt – Audi · 56 torque figures
- Removing engine – Audi A8 D3 · 41 torque figures
- Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
- Installing engine – Audi A8 D4 · 36 torque figures
- Removing and installing camshaft timing chain · 29 torque figures
- Testing signal from fuel gauge sender -G
- Removing and installing steel wheel bearing housing
- Checking control valve and spring cylinder for leaks
- Centring front axle camber
- Assembly overview: Power steering/fluid circuit for 8-cylinder petrol engine
Who makes these pages, and how
TorqFix was built by a mechanic — after a 2,700 km drive with five roadside repairs that no diagnostic tool could explain.
The figures on this page come from manufacturer workshop documentation and are shown as they are. The page is assembled automatically from that data — it is not written by an AI. The AI works in the chat, where it answers for your specific car. It writes nothing here.
Variants of the same model differ. Cross-check torque against the factory manual for your engine before final tightening.
Seen a figure that does not match your manual? Write to us — we correct it and note when. support@torqfix.com
The story behind TorqFix →Workshop data on this page last updated 20 Sep 2026.