Removing and installing four-way lumber support - vehicles up to model year 2005 — AUDI

🧭 Before you start

Fits: Audi A4 Cabriolet B6/B7 (8H)

📋 Procedure

1. Remove seat .
2. Attach seat repair standVAS 6136 to engine and gearbox supportVAS 6095.
3. Attach front seat to seat repair standVAS 6136.
4. Remove side trim (sill side) .
5. Remove side trim (tunnel side) .

6. Remove backrest .
7. Remove backrest cover panel .
8. Remove outer backrest frame .
9. Disengage Bowden cable for lumbar support adjustment (2) at hook (4).
10. Disengage Bowden cable for lumbar support height adjustment (1) at retaining pin (5) and at guide roller (6).
11. Disengage bottom of four-way lumbar support (3) at locations marked (B) (2x).
12. Disengage top of four-way lumbar support (3) at locations marked (A) (2x).
13. Install in reverse order of removal.

Other AUDI procedures

• Removing and installing toothed belt – Audi · 56 torque figures
• Removing engine – Audi A8 D3 · 41 torque figures
• Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
• Installing engine – Audi A8 D4 · 36 torque figures
• Removing and installing camshaft timing chain · 29 torque figures
• Removing and installing centre rear seat belts · 1 torque figures
• Assembly overview - poly V-belt drive · 1 torque figures
• Removing and installing high-pressure accumulator (rail)
• Removing and installing rear handbrake cable
• Adjusting main beam headlights on roof · 1 torque figures