Removing and installing starter, 2.0 l natural gas engine, manual gearbox — AUDI

🧭 Before you start

Fits: VW Caddy III (2K, 2004–2015); platform code 2C0

📋 Procedure

1. ⚠ To disconnect and reconnect the battery, the procedure described in the workshop manual should be strictly adhered to . — Disconnect battery .
2. Loosen spring-type clip (1) using spring-type clip pliersVAS 5024.
3. Remove securing bolt (2).
4. Release hose (3) and pull off air filter housing.
5. Pull air filter housing upwards on right-hand side out of rubber mounting (arrow).

6. Remove air filter housing from vehicle.
7. Push protective cap off solenoid switch downwards in direction of (arrow).
8. Release and disconnect connector of terminal 50 (2).
9. Unbolt positive cable (1).
10. Unscrew and remove earth wire from bolt securing the starter (arrow).
11. Undo upper starter bolt (arrow).
12. If fitted, remove noise insulation General body repairs, exterior66Noise insulation.
13. Unscrew nut (1) of lower bolt securing starter and remove wiring retainer (2).
14. Undo lower starter bolt (arrow).
15. Remove starter.
16. Tighten threaded connections to specified torque given in assembly overview .

Other AUDI procedures

• Removing and installing toothed belt – Audi · 56 torque figures
• Removing engine – Audi A8 D3 · 41 torque figures
• Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
• Installing engine – Audi A8 D4 · 36 torque figures
• Removing and installing camshaft timing chain · 29 torque figures
• Removing and installing balance shaft assembly with chain drive · 3 torque figures
• Removing and installing rear window – Audi A5 · 1 torque figures
• Removing and installing rear wheel speed sensor – Audi · 3 torque figures
• Installing engine - vehicles with hybrid drive – Audi Q5 2.0 · 1 torque figures
• Adjusting pinion shaft when dimension "„E“" is marked on outer circumference of crown wheel · 3 torque figures