Vehicles with 2.0 l natural gas engine and manual gearbox — VW
Vehicles with 2.0 l natural gas engine and manual gearbox on VW: 10 steps. What to remove, in what order, and what to check after.
Workshop procedure for VW — the exact step sequence and torque figures, straight from real workshop data.
🧭 Before you start
Fits: VW Touran I (1T, 2003–2015)
📋 Procedure
- Disconnect battery .
- Slide protective cap off solenoid switch in direction of (arrow).
- Unscrew positive wire (1) and disconnect connector from terminal 50 (2).
- Unscrew earth wire from starter securing bolt (arrow).
- Remove securing bolt of starter (arrow).
- Remove noise insulation General body repairs, exterior50Noise insulation.
- Unscrew nut (1) from lower securing bolt of starter and remove wiring retainer (2).
- Remove securing bolt of starter (arrow).
- Remove starter.
- Tighten threaded connections to specified torques .
Other VW procedures
- Removing engine · 41 torque figures
- Removing and installing camshaft – VW Golf Cabriolet · 47 torque figures
- Adjusting valve timing – VW Passat B5 · 83 torque figures
- Removing and installing camshafts – VW Passat B6 · 39 torque figures
- Removing and installing coolant pump · 53 torque figures
- Adjusting output shaft for 5th, 6th and reverse gears – VW 2.0
- Leak-proofness of the steering system - check
- Differential - disassemble and assemble
- 4 - Speed automatic gearbox 001 — 1st to 3rd gear clutch -K1-: disassemble and assemble
- 4 - Speed automatic gearbox 001 — 3rd and 4th gear clutch -K3-: disassemble and assemble
Who makes these pages, and how
TorqFix was built by a mechanic — after a 2,700 km drive with five roadside repairs that no diagnostic tool could explain.
The figures on this page come from manufacturer workshop documentation and are shown as they are. The page is assembled automatically from that data — it is not written by an AI. The AI works in the chat, where it answers for your specific car. It writes nothing here.
Variants of the same model differ. Cross-check torque against the factory manual for your engine before final tightening.
Seen a figure that does not match your manual? Write to us — we correct it and note when. support@torqfix.com
The story behind TorqFix →Workshop data on this page last updated 20 Sep 2026.