Removing and installing starter, 1.2 l, 77 kW injection engine with manual gearbox MQ200-6F — VW

🧭 Before you start

Fits: VW Golf Cabriolet (517, 2011–2016)

📋 Procedure

1. Disconnect battery .
2. Remove air filter housing Power unit24Fuel injection system; Assembly overview - air filter.
3. Push protective cap off solenoid switch downwards in direction of (arrow).
4. Undo nut (1) and detach positive wire from connection thread of solenoid switch.
5. Release and pull off terminal 50 connector (2).

6. Unscrew nut (arrow) and take earth wire off upper securing bolt of starter.
7. Remove upper securing bolt of starter (arrow).
8. Remove noise insulation General body repairs, exterior50Body front; Noise insulation.
9. Undo nut (1) and remove it from lower securing bolt of starter.
10. Remove cable retainer (2).
11. Remove lower securing bolt of starter (arrow).
12. Remove starter downwards from vehicle.
13. Tighten threaded connections to torque specified in assembly overview .

Other VW procedures

• Removing engine · 41 torque figures
• Removing and installing camshaft – VW Golf Cabriolet · 47 torque figures
• Adjusting valve timing – VW Passat B5 · 83 torque figures
• Removing and installing camshafts – VW Passat B6 · 39 torque figures
• Removing and installing coolant pump · 53 torque figures
• Removing and installing alternator, 1.9 l TDI engine with DSG
• Removing and installing starter, vehicles with 4.9 l, 230 kW TDI engine, automatic gearbox AL750-6A
• Removing and installing relay carrier in front right footwell · 1 torque figures
• Removing and installing alternator, 1.4 l 55 kW injection engine
• Removing and installing engine control unit - Jetta from MY 2011