TorqFix

Removing and installing rear side panel (top) — AUDI

Removing and installing rear side panel (top) on Audi: 11 steps. What to remove, in what order, and what to check after.

Workshop procedure for AUDI — the exact step sequence and torque figures, straight from real workshop data.

11 steps

🧭 Before you start

Fits: platform code 42

📋 Procedure

  1. Remove side panel trim .
  2. Remove rear side panel (bottom) .
  3. Remove left or right engine compartment trim .
  4. Remove tail light Electrical system94.
  5. Unscrew bolts (arrows) from rear side panel (top) (1).
AUDI? Steps differ between engine variants — check this job against your exact car before you commit to it. Check my car — free →
  1. Remove bolts (arrows).
  2. Cut open cable tie (2).
  3. Detach rear side panel (top) (1).
  4. Install engine compartment trim .
  5. Install rear side panel (bottom) .
  6. Install side panel trim .

Who makes these pages, and how

TorqFix was built by a mechanic — after a 2,700 km drive with five roadside repairs that no diagnostic tool could explain.

The figures on this page come from manufacturer workshop documentation and are shown as they are. The page is assembled automatically from that data — it is not written by an AI. The AI works in the chat, where it answers for your specific car. It writes nothing here.

Variants of the same model differ. Cross-check torque against the factory manual for your engine before final tightening.

Seen a figure that does not match your manual? Write to us — we correct it and note when. support@torqfix.com

The story behind TorqFix →

Workshop data on this page last updated 20 Sep 2026.