TorqFix

Removing and installing anti-roll bar, Crafter 4MOTION with Achleitner four-wheel drive — AUDI

Removing and installing anti-roll bar, Crafter 4MOTION with Achleitner four-wheel drive on Audi: 11 steps.

Workshop procedure for AUDI — the exact step sequence and torque figures, straight from real workshop data.

11 steps

🧭 Before you start

Fits: platform codes 2EA, 2ED, 2EH, 2EX, 2EB, 2EE, 2EK, 2FC, 2FF, 2FL, 2FZ, 2FG, 2FM

  • Renewed: if necessary

📋 Procedure

  1. Raise vehicle and strap it down 10.2.
  2. ⚠ If the vehicle is not strapped down, it may slip off the lifting platform. — If fitted, remove noise insulation General body repairs, exterior50Body - front; Noise insulation.
  3. Unscrew bolt (arrows) and remove coupling rod bracket (1).
  4. Loosen coupling rods from coupling rod bracket .
  5. Unscrew bolts (arrows) and remove clamps (A).
AUDI? Steps differ between engine variants — check this job against your exact car before you commit to it. Check my car — free →
  1. Remove anti-roll bar (C) with anti-roll bar bearing (B).
  2. Check anti-roll bar (B) and clamps (A) for wear and damage and renew if necessary. [Note: Tighten bolted connections to coupling rods only if the vehicle is standing on its wheels and is unladen or if the vehicle is raised and is in the unladen position (normal position) .Whilst installing the anti-roll bar ensure that the surface is not damaged. Rectify paint work damage if necessary and protect against corrosion with underseal.When installing, ensure that the outer edges of the rubber bush lie against stop of anti-roll bar.]
  3. Tighten anti-roll bar bolts hand-tight.
  4. Centre anti-roll bar.
  5. Fit coupling rods on coupling rod bracket.
  6. Tighten anti-roll bar bolts.

Who makes these pages, and how

TorqFix was built by a mechanic — after a 2,700 km drive with five roadside repairs that no diagnostic tool could explain.

The figures on this page come from manufacturer workshop documentation and are shown as they are. The page is assembled automatically from that data — it is not written by an AI. The AI works in the chat, where it answers for your specific car. It writes nothing here.

Variants of the same model differ. Cross-check torque against the factory manual for your engine before final tightening.

Seen a figure that does not match your manual? Write to us — we correct it and note when. support@torqfix.com

The story behind TorqFix →

Workshop data on this page last updated 20 Sep 2026.