Removing and installing radio system "“RCD 310”" — AUDI

🧭 Before you start

Fits: VW Transporter T5 (7H), VW Transporter T6 (7E), VW Transporter T6 (7F)

• Special tools named: T10057, locking bar

Don't miss

• The number and the fitting locations of connectors on the unit can vary according to the different radios or radio/navigation systems.
• The number of connectors on the unit can vary according to the different radio or radio navigation systems.

📋 Procedure

1. Remove any CDs left in the unit Operating manual.
2. Switch off ignition and all electrical loads, and pull out ignition key.
3. Slide radio release tools T10057 into release slots (arrows) until they engage.
4. Using the grip rings of the release tools, pull radio out of dash panel (arrow) until connectors at rear are accessible.
5. Unclip storage compartment (1) above radio.

6. Unscrew the 2 securing bolts (1).
7. First carefully unclip cover (2) at top and then at bottom using removal wedge3409.
8. Remove cover (2).
9. Unscrew the 4 securing bolts (arrows) from radio system.
10. Pull radio system out of installation slot until connectors at rear are accessible. [Note: The number and the fitting locations of connectors on the unit can vary according to the different radios or radio/navigation systems.]
11. Press locking mechanism of connector together in (direction of arrow).
12. Swing locking bar up in (direction of arrow) and pull out connector.
13. Release and disconnect connectors (arrows) from aerial connections. [Note: The number of connectors on the unit can vary according to the different radio or radio navigation systems.]
14. Connect connectors to radio and engage them.
15. ⚠ Risk of damage to display and operating keys!When inserting the radio system into the installation slot by pressing against the display or operating keys, the unit could become damaged.When inserting the radio system never press against the display or operating keys. — Slide radio system straight into dash panel.
16. Screw in and tighten the 4 securing bolts (arrows).
17. Install centre console cover.
18. If necessary, deactivate anti-theft coding .
19. Check coding of radio and re-code if necessary .

Other AUDI procedures

• Removing and installing toothed belt – Audi · 56 torque figures
• Removing engine – Audi A8 D3 · 41 torque figures
• Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
• Installing engine – Audi A8 D4 · 36 torque figures
• Removing and installing camshaft timing chain · 29 torque figures
• Removing and installing left coolant pipes
• Removing and installing brake pads or linings
• Removing and installing axle beam, front-wheel drive
• Renewing desiccant bag for condenser, Caddy 2011 ►
• Removing and installing sill panel moulding