Removing and installing left coolant pipes — AUDI

🧭 Before you start

Fits: VW Caddy IV (SA, 2015–2020)

• Opens: coolant

Don't miss

• Secure all hose connections with the hose clips corresponding to original equipment Electronic Parts Catalogue (ETKA).

🔧 Engine codes this applies to

📋 Procedure

1. Drain coolant .
2. Remove air filter housing .
3. Remove air pipe .
4. Unbolt cable support bracket from gearbox, and push it aside slightly 34Selector mechanism; Removing and installing selector mechanism.
5. Free electrical wiring harness (1).

6. Remove nut (4).
7. Unscrew bolts (2) and (3).
8. Loosen clamps (arrow).
9. Pull off coolant hoses.
10. Detach coolant pipes (left-side).
11. Free electrical wiring harness (1).
12. Remove nut (4).
13. Unscrew bolts (2) and (3).
14. Loosen clamps (arrow).
15. Pull off coolant hoses.
16. Detach coolant pipes (left-side). [Note: Secure all hose connections with the hose clips corresponding to original equipment Electronic Parts Catalogue.]
17. Replenish coolant .

Other AUDI procedures

• Removing and installing fuel pressure regulating valve, version 1
• Removing and installing fuel tank, front-wheel drive
• Removing and installing upper toothed belt guard – VW
• Removing and installing cooler for charge air cooling circuit
• Checking return flow rate of injectors at starter speed – VW
• Removing and installing toothed belt – Audi · 56 torque figures
• Removing engine – Audi A8 D3 · 41 torque figures
• Removing camshaft timing chain from camshafts – Audi A6/A7 C7 · 38 torque figures
• Installing engine – Audi A8 D4 · 36 torque figures
• Removing and installing camshaft timing chain · 29 torque figures